Sony RM-VLZ620 Operating Instructions Manual page 30

Notes
 You can press any button other than
the SET or SYSTEM CONTROL
buttons.
 You can skip the POWER button for
Sony devices by using automatic
power-on control instead.
 If you have programmed an incorrect
operation by mistake, the setting is
canceled. Start from the beginning.
 If you press a Device Select button in a
consecutive procedure, the function
already learned on the button will not
be programmed.
5
Press SET to complete the
programming.
The SET indicator flashes three
times and turns off.
3 flashes
To cancel the process
Press and hold SET for more than 3
seconds. The SET indicator turns
off.
To clear a programmed
procedure
1
Press and hold SET for more than
3 seconds.
The SET indicator lights up.
While keeping SET held down,
press .
2
Enter  - 8 - 1.
The SET indicator flashes three
times.

Press and hold the programmed
button you want to reset for more
than 3 seconds.
When the programmed
procedure is cleared, the SET
indicator flashes three times and
turns off.
0
If your device does not
accept consecutive remote
control signals
If the device does not respond to the
next signal immediately after the
power-on signal, you can insert
other signals or an interval by
pressing the same Device Select
button.
For Example, if TV power-on and
input select do not work properly:
 Insert another device signal by
pressing
TVPOWERDVD
POWERTVINPUT
 Insert a 0.3 second interval
between each signal by pressing
TVPOWERTVINPUT
(Added signals are underlined.)
Notes
 If you interrupt the procedure at any point
for over 10 seconds, the setting mode ends.
Start again from the beginning.
 If you try to program more than 16 steps,
the setting mode ends, and the 16 steps you
have programmed are registered.
 If you change the manufacturer's code or
teach a new signal on a button that has been
programmed for a consecutive procedure,
the new signal will be transmitted when you
press the corresponding Device Select
button.