Sony RM-VL710 Operating Instructions Manual page 9

3
Press the Component Select
button for the desired
component.
The selected Component Select
button lights up, and all other
button lights turn off.
TV VCR
4
Press the Number buttons
to enter the four-digit
component code number.
5
Press ENT.
The Component Select button
light turns off.
TV
If the Component Select button
flashes five times before
turning off, it means that the
setup is incomplete. Start over
from Step 2.
CBL DVD AMP
TV
Notes
• If you press a component code
number that is not on the table in the
supplied "Component Code
Numbers", or if you press a button in
the wrong order, the Component
Select button flashes five times, and
then turns off. Check the component
code number, and try setting it again.
• If you don't input anything into the
Commander within 20 seconds
between each step, the setup
procedure will be canceled. To set the
code, start over from Step 2.
• If you press SET while setting the
component code, all code numbers
will be lost, and the setup procedure
will be canceled. Start over from Step
2.
To cancel setup, press SET.
Continued
9