Setting a component code by
the Search function (continued)
The Component button turns
If the Component Select button
flashes five times before turning
off, it means that the setup is
incomplete. Start over from Step 1.
Check if the code number
works by following the
instructions on page 10.
• If you don't input anything into the
Commander within 20 seconds
between each step, the setup
procedure will be canceled. To set the
code, start over from the beginning.
• If you press any button other than
CH +/– and POWER while setting
the component code, all code
numbers will be lost, and the setup
procedure will be canceled. Start over
from the beginning.
To cancel setup, press SET.
Components with the
When you operate a non-Sony
component, make sure you set the
component code first (page 8).
Example: To operate a video
Press the desired
Component Select button.
The Component Select button
lights up when you press it,
and turns off when you release