Changing Or Erasing The Function Of A "Learned" Button - Sony RM-VL700 Operating Instructions (primary manual) Operating Instructions Manual

Changing or erasing the
function of a "learned"
button
To change the "learned" function,
clear it first and perform Learning
again.
To clear the "learned" function
of a single button
Example: To erase the "learned"
function from the Number
button 1 in VCR mode
1
Press and hold SET for over
3 seconds.
The SET indicator lights up,
and all Component Select
buttons flash.
2
While holding the desired
Component Select button
pressed, press the button
you want to erase.
+
The SET indicator turns off,
and the selected Component
Select button lights up.
during data
erasing
Note
Be sure to press the button you
want to erase while pressing the
Component Select Button. If you
release the Component Select
button, the Commander changes to
Learning mode.
3
Press SET to finish setting.
To cancel erasing, press SET.
data erasing
complete
Continued
21