Sony RM-VL700 Operating Instructions (primary manual) Operating Instructions Manual page 20

Programming signals of another
remote control
— Learning Function (continued)
3 Press and hold the button
on the other remote control,
until the SET indicator
lights and all the
Component Select buttons
flash again.
During data transfer, only the
SET indicator stays lit, and the
Component Select button turns
off.
If the SET indicator flashes
five times
It means that "learning" is
incomplete. Repeat Steps 2 and 3.
4 Repeat Steps 2 and 3 to
"teach" remote control
signals to other buttons.
5 Press SET to finish
"learning."
20
Notes
• If you do not perform Learning
steps within 20 seconds at any
point during the process,
Learning mode ends.
• If you do not perform Step 3
within 10 seconds after Step 2, the
Learning procedure returns to
Step 1. Repeat from Step 2 while
the Component Select button
lights.
To cancel "learning," press SET.