Installing The Usb Driver - Sony RM-AX4000 Operating Instructions Manual

4
Click [Next].
Follow the on-screen instructions and
proceed with the installation.
When the installation is complete,
"AX Remote Editor 1.0 Setup"
automatically quits.
Tip
If the installation display is hidden
behind other windows
If "AX Remote Editor 1.0 Setup" disappears
behind other displays while installing,
press the [Tab] key several times while
pressing down the [Alt] key to bring up
"AX Remote Editor 1.0 Setup" again.

Installing the USB driver

You need to install the USB driver before
connecting the supplied USB mini cable
to your PC and the Remote Commander.
Follow the instructions below to install.
Notes
• Without batteries in the Remote Commander,
the USB connection cannot be detected by the
PC even if the USB mini cable is connected.
Make sure to install the batteries before
installing the USB driver. If the USB driver
installation is interrupted by mistake, install
it again from the beginning.
• Do not simply copy the USB driver in the
supplied CD-ROM to the PC. You need to
install it properly for it to work.
• On Windows 2000 or Windows XP, logon
with an authorized "Administrator" ID when
installing the USB driver.
• On Windows 2000 or Windows XP, you need
to install the driver for each port to which the
Remote Commander will be connected.
• Depending on the PC, various messages
other than those mentioned in this manual
may appear during the USB driver
installation. Just follow the on-screen
instructions of these messages to install.
Continued
17