Selecting A Channel With A Single Key Press - Channel Macro Function - Sony RM-AV2500T Operating Instructions Manual

To receive the data of a
Component Select button from
another remote commander
1~2
Perform Steps 1 and 2 on page
40.
3
Press the 2 key.
4
Press the Component Select
button to which want to assign
the data.
5
Press the ENTER key.
When the data have been received,
"TV" and "r" go off. If the data have
been successfully received, the
backlight of the display turns off.
Notes
• If the Commander is not ready for
receiving the data, press CLEAR key, then
OK key to clear the learned signal on all
or one of the Component Select buttons.
• If "NG" appears during data transfer, go
back to Step 3 and continue the operation
or press COMMANDER OFF to stop the
operation. If you continue the operation,
you have to set the sending remote
commander again to send data.
Selecting a Channel
with a Single Key Press
— Channel Macro Function
You can programme the Channel Macro
function for the keys listed below (macro
keys).
If you programme the operation of
entering the 1, 2, 3 and ENTER keys for a
macro key, you can select the channel 123
by pressing that single key.
Component Macro key
TV: PIP STILL, PIP TEXT, PIP
CH+, PIP MOVE, PIP
SWAP, PIP CH-
CBL: m, N, M, REC*, x, X
SAT: m, N, M, REC*, x, X
* You can programme this function for REC
key alone (not on the REC + B key for a
double-key operation).
2
TV SAT VCR
CD MD
TAPE
PROGRAM
1
5
DVD CBL AMP
M1 M3
M2
Continued
GB
41