Adding A Command That Is Required When Selecting A Component - Sony RM-AV2500T Operating Instructions Manual

Adding an Extra Function to the
Component Select Buttons
(continued)
Adding a command that is
required when selecting a
component
In addition to the original function of
selecting the operating keys and buttons
of the desired component, the
Component Select button can have
another remote control signal by
"learning."
For example, if you always have to
change input select of the amplifier to CD
when listening to the CD player,
programme the signal of "changing the
amplifier's input select" to the CD button
of this Commander. Then whenever you
press the CD button, it automatically
works as the original CD Component
Select button and changes also the
amplifier input select to CD. (In this case,
the amplifier should be turned on first.)
Note
Some specific remote control signals may not
be learned.
TV
3
CD
GB
32
PROGRAM
SAT VCR DVD CBL AMP
MD M1 M3
TAPE M2
Example: To programme the
input select signal of your
amplifier to the CD button
1
Place the RM-AV2500T head to
head with your component's
remote control.
Remote control of
your component
about 2 – 4 inches
(5 – 10 cm) away
2
While pressing COMMANDER
OFF, press PROGRAM + and
w +.
Learnable SYSTEM CONTROL keys
and number keys flash in the display
panel.
2
Note
The name of a Component Select button for
which a signal has already been learned
stays lit. If you want to programme a new
5 signal for that button by learning, clear the
learned signal first (page 33).
RM-AV2500T
PROGRAM