Programming A Series Of Commands To The System Control Buttons - Sony RM-AV2100T Operating Instructions Manual

Executing a Series of Commands
— System Control Functions
(continued)
Programming a series of
commands to the SYSTEM
CONTROL buttons
Example: To programme the
procedure above to the SYSTEM
CONTROL 2 button
1
While pressing COMMANDER
OFF, press one of the SYSTEM
CONTROL buttons (in this case,
SYSTEM CONTROL 2).
All the component names flash.
24
GB
If a series of commands is already
programmed for that button
That programme will be displayed.
(At the factory, the SYSTEM
CONTROL 1 button is preset with the
System Power-Off function for Sony
components (the same function as
explained in page 34), and the
SYSTEM CONTROL 3 button is
factory preset with standard power-
on command for nearly all Sony
components.)
To programme a new series of
operations, clear the programme first
(page 26).
2
Press the Component Select
buttton for the component to
operate.
The keys for the selected component
flash.
If the component has the power-
on and power-off signals
Both the OFF and ON keys are displayed
and you can select either of them to
programme.
It is useful to set the exact command for
power-on or power-off and operate the
component regardless of its status (on/off).