Sony RM-AV2100T Operating Instructions Manual page 17

The "P+ P- V+ V- MU" display
indicates if PROGRAM +/–, 2 +/–
and % buttons are learnable or not.
Note on the flashing display
The keys or buttons that are already preset
for that component flash twice while those
that are not preset flash once.
3
Press the key or button on the
Commander you want to "teach".
"LEARN" flashes and the only
pressed key remains on the dislplay.
To teach on the PROGRAM +/–, 2
+/– or % buttons
Press the corresponding button. "LEARN"
flashes, and only the pressed button
remains indicated on the display ("P+,"
"P–," "V+," "V–," or "MU").
Example: When pressing the 2 + button
To change the function display of
the key
Follow the procedure on page 19.
4
Press and hold down the button
on the other remote control until
you hear a beep.
(If you release the button before you
hear a beep, the signal may not be
learned correctly.)
"LEARN" stops flashing and stays lit.
When the command has been learned
successfully, the learned keys stay lit
and the other learnable keys flash.
If "NG" flashes on the display
Learning did not succeed. Try Steps 3 and 4
again.
5
Repeat Steps 3 and 4 to teach
functions to other kyes or
buttons.
To learn another component's
remote control signal
After positioning the two remote
commanders as in Step 1 on page 16, press
the corresponding Component Select
button, and then follow Steps 3 and 4 on
the left to perform learning.
6
Press COMMANDER OFF.
17
Continued
GB