Setting The Time Groups - Siemens MTCO 1324 Operating Instructions Manual

 a) Push the blocked drawer in until it
latches.
b) Bring the hinged drawer into a hori-
zontal position and push it in until it
latches.
 The basic display is shown:
½ including date, time, and the total
number of kilometres,
½ additionally, the symbols for the insert-
ed charts, and current position of the
time groups, on the left for driver 1 and
on the right for driver 2 are displayed.
Notes on the basic display
• The time of the MTCO 1324 is adjusted to
the legal time of the country where the
vehicle has been registered. The start and
the end of the daylight saving time are
deposited within the device and will be
updated automatically.
➥ See also page 33 "Error code - over-
view".
• In case an exclamation mark appears next
to the total kilometre reading, there has
been a failure.
➥ See also page 33 "Error code - over-
view".
• Option: digital v-display
Depending on the design, the vehicle
speed display may be shown in
the1st line. Otherwise all functions are
analogous to the basic display.
28

Setting the time groups

2 driver operation
 Driver 1 presses the
½ Press the key several times, until the
desired time group is shown in the
display.
Driver 2 presses the
½ Press the key several times, until the
desired time group is shown in the
display.
As soon as the vehicle starts to drive, there
will be an automatic display of the basic
display
• for the driver 1 "
• for the driver 2 "
1 driver operation
• Only insert the chart for driver 1 on the
separating plate during 1 driver operation.
• Set the time group for driver 2 in any case
to break time "
be an error message.
Time group distribution
= driving times
= remaining working times
= availability
(waiting times, co-driver times, times
in sleeping cabin during ride)
= break times and restoring periods
key.
key.
" and
".
" otherwise there will
Kienzle MTCO 1324