Sony ZS-D7 Operating Instructions Manual page 46

Connecting optional components (continued)
Tip
You can record the
sound of the connected
component. Insert a
blank tape into the tape
compartment, and
press r/P then ( on
the tape section.
Notes
• As long as "CD"
appears in the display,
the optical digital
output jack is in
operation and the jack
lights even if the CD is
in stop mode.
• If you play a CD that is
not for audio use, such
as a CD-ROM, noise
may be heard.
46 EN
Setting Up
Listening through the speakers of other audio
equipment
Amplifier
to line input jack Audio connecting
cable RK-G129HG
(1.5 m) (not supplied)
1 Connect the LINE OUT jack of this player with the
analog line input jack of the amplifier, etc., using
the audio connecting cable (not supplied) .
2 Turn on the power of this player.
Recording a CD on a DAT recorder
DAT recorder,
etc.
to digital input
Digital connecting
jack
cable* POC-DA12P,
etc. (not supplied)
1 Connect the digital connecting cable (not supplied)
to the digital input jack the DAT recorder and the
OPTICAL DIGITAL OUT jack of this player.
2 Turn on the power of this player and the connected
component.
3 Start recording on the connected component.
4 Start playing a CD on this player.
* Select the connecting cable depending on the type of the
digital input jack of the recorder to be connected. For
details, refer to the instruction manual of the component to
be connected. The OPTICAL DIGITAL OUT (CD) jack of
this player is square-shaped jack.
Front panel of this
player
to LINE OUT
Front panel of
this player
to OPTICAL
DIGITAL OUT (CD)