Sony ZS-D10 Marketing Specifications & Features Operating Instructions

Notes on CDs
Precautions Troubleshooting
• Before playing, clean the CD with a
cleaning cloth. Wipe the CD from the
center out.
On safety
General
• As the laser beam used in the CD player
The power does not come on.
section is harmful to the eyes, do not
• Connect the AC power adaptor to a wall outlet
attempt to disassemble the casing. Refer
securely.
servicing to qualified personnel only.
There is no audio.
• Should any solid object or liquid fall into
• Make sure the function you want to use
the player, unplug the player, and have it
appears in the display window.
checked by qualified personnel before
• Adjust the volume.
operating it any further.
• Unplug the headphones when listening
• Discs with non-standard shapes (e.g.,
through speakers.
heart, square, star) cannot be played on • Do not use solvents such as benzine,
Noise is heard.
thinner, commercially available cleaners
this player. Attempting to do so may
• Someone is using a portable telephone or
damage the player. Do not use such discs. or anti-static spray intended for vinyl LPs.
other equipment that emits radio waves near
• Do not expose the CD to direct sunlight or the player. tMove the portable telephone,
Cleaning the cabinet
heat sources such as hot air ducts, nor etc., away from the player.
• Clean the cabinet, panel and controls with
leave it in a car parked in direct sunlight as
CD Player
a soft cloth slightly moistened with a mild
there can be a considerable rise in
detergent solution. Do not use any type of
temperature inside the car. The CD does not play or "no dISC"
abrasive pad, scouring powder, or solvent,
• Do not stick paper or sticker on the CD, lights in the display even when a CD
such as alcohol or benzine.
nor scratch the surface of the CD. is in place.
• After playing, store the CD in its case. • Place the CD with the label surface you.
On power sources
If there is a scratch, dirt or fingerprints on the • Make sure that the CD compartment is closed.
• For AC operation, use the supplied AC
CD, it may cause tracking error. • Clean the CD.
power adaptor; do not use any other type.
• Take out the CD and leave the CD
About CD-Rs/CD-RWs
compartment open for about an hour to dry
This player can play CD-Rs/CD-RWs moisture condensation.
recorded in the CD-DA format*, but • Make sure "Cd" appears in the display.
playback capability may vary depending on • The CD-R/CD-RW was not finalized. Finalize
Polarity of the plug
the quality of the disc and the condition of the CD-R/CD-RW with the recording device.
• There is a problem with the quality of the CD-
the recording device.
• The player is not disconnected from the R/CD-RW, recording device, or application
* CD-DA is the abbreviation for Compact
software.
AC power source (mains) as long as it is
Disc Digital Audio. It is a recording
connected to the wall outlet, even if the The sound drops out.
standard used for Audio CDs.
player itself has been turned off.
Noise is heard.
• Unplug the player from the wall outlet Music discs encoded with copyright
• Reduce the volume.
when it is not be used for an extended protection technologies • Clean the CD, or replace it if the CD is badly
period of time. damaged.
This product is designed to play back discs
• When the batteries are not to be used, • Place the player in a location free from
that conform to the Compact Disc (CD)
remove them to avoid damage that can be vibration.
standard. Recently, various music discs
• Clean the lens with a commercially available
caused by battery leakage or corrosion.
encoded with copyright protection
blower.
• The nameplate indicating operating
technologies are marketed by some record
• The sound may drop out or noise may be
voltage, etc. is located at the rear.
companies. Please be aware that among
heard when using poor quality CD-Rs/CD-
those discs, there are some that do note
On placement
RWs or if there is a problem with the
conform to the CD standard and may not by
recording device or application software.
• Do not leave the player in a location near
playable by this product.
heat sources, or in a place subject to direct
sunlight, excessive dust or mechanical
shock. If you have any questions or problems
concerning your player, please consult your
• Do not place the player on an inclined or
unstable place. nearest Sony dealer.
• Do not place anything within 10 mm of
the side of the cabinet. The ventilation
holes must be unobstructed for the player
to operate properly and prolong the life of
its components.
• If the player is left in a car parked in the
sun, be sure to choose a location in the car
Radio
where the player will not be subjected to
Reception is poor.
the direct rays of the sun.
• Reorient the antenna to improve FM
• Since a strong magnet is used for the
reception.
speakers, keep personal credit cards using
magnetic coding or spring-wound watches
away from the player to prevent possible
damage from the magnet.
On operation
• If the player is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may condense
• Reorient the player itself to improve AM
on the lenses inside the CD player section.
reception.
Should this occur, the player will not
operate properly. In this case, remove the
CD and wait about an hour for the
moisture to evaporate.
The audio is weak or has poor quality.
• Move the player away from the TV.
• If you are using the remote while listening to
AM radio, noise may be heard. This is
unavoidable.
The picture of your TV becomes
unstable.
• If you are listening to an FM program near the
TV with an indoor antenna, move the player
away from the TV.
Remote
Specifications
The remote does not function.
• Replace the battery in the remote with new
one if it is weak.
• Make sure that you are pointing the remote at
AUDIO POWER SPECIFICATIONS
the remote sensor on the player.
POWER OUTPUT AND TOTAL
• Remove any obstacles in the path of the
HARMONIC DISTORTION
remote and the player.
With 6-ohm loads, both channels driven
• Make sure the remote sensor is not exposed to
from 1 000 - 10 000 Hz; rated 3.5 W per
strong light such as direct sunlight or
channel-minimum RMS power, with no
fluorescent lamp light.
more than 10 % total harmonic distortion
• Move closer to the player when using the
in AC operation.
remote.
Other specifications
After trying the above remedies, if you still have
CD player section
problems, unplug the AC power adaptor. After
System
all the indications in the display disappear, plug
the AC power adaptor. If the problem persists, Compact disc digital audio system
please consult your nearest Sony dealer. Laser diode properties
Material: GaAlAs
Wave length: 780 nm
Emission duration: Continuous
Laser output: Less than 44.6 µW
(This output is the value measured at a distance
of about 200 mm from the objective lens surface
on the optical pick-up block with 7 mm
aperture.)
Spindle speed
200 r/min (rpm) to 500 r/min (rpm)
(CLV)
Number of channels
2
Frequency response
20 - 20 000 Hz +1/–2 dB
Wow and flutter
Below measurable limit
Radio section
Frequency range
FM: 87.5 - 108 MHz
AM: 531 - 1 611 kHz (Taiwan model)
530 - 1 710 kHz (Other models)
Antennas
FM: Telescopic antenna
AM: Built-in ferrite bar antenna
General
Speaker
Full range: 8 cm (3 1 ⁄ in.) dia., 6 , cone type
4
(2)
Input
Lens
LINE IN jack (stereo minijack):
Minimum input level 330 mV
Outputs
Headphones jack (stereo minijack):
For 16 - 68 impedance headphones
OPTICAL DIGITAL OUT (CD) (optical output
connector):
Wavelength 630 - 690 nm
Power output
4 W + 4 W (at 6 , 10% harmonic
distortion)
Power requirements
For Personal Audio System:
DC IN 10V jack accepts: Supplied AC power
adaptor for use with: 120V AC, 60 Hz
For remote control:
3 V DC, 2 size AAA (R03) batteries
Dimensions
Approx. 530 195 127 mm (w/h/d)
(20 7 ⁄ 7 3 ⁄ 5 inches) (incl. projecting parts)
8 4
Mass
Approx. 2.5 kg (5 lb. 8 oz)
Supplied accessory
AC power adaptor (1)
Remote control (1)
Design and specifications are subject to change
without notice.
Optional accessories
Sony MDR headphone series
Information
English
For customers in the USA
WARNING This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
To prevent fire or shock hazard, do
These limits are designed to provide reasonable
not expose the player to rain or
protection against harmful interference in a
moisture. residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in
Personal
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
Audio
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
System
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
This symbol is intended to alert the — Reorient or relocate the receiving antenna.
Operating Instructions
user to the presence of uninsulated
— Increase the separation between the
"dangerous voltage" within the
equipment and receiver.
product's enclosure that may be of
— Connect the equipment into an outlet on a
sufficient magnitude to constitute a
circuit different from that to which the
risk of electric shock to persons.
receiver is connected.
— Consult the dealer or an experienced radio/
This symbol is intended to alert the
TV technician for help.
user to the presence of important
This class B digital device complies with part 15
operating and maintenance
of the FCC rules. Operation is subject to the
(servicing) instructions in the
following two conditions: (1) This device may
literature accompanying the
not cause harmful interference, and (2) this
appliance.
device must accept any interference received,
including interference that may cause undesired
CAUTION
operation.
The use of optical instruments with this product
You are cautioned that any changes or
will increase eye hazard.
modifications not expressly approved in this
manual could void your authority to operate this
WARNING
equipment.
Do not install the appliance in a confined space,
such as a bookcase or built-in cabinet.
Replace the AC power adaptor with model AC-
ZS-D10 To prevent fire or shock hazard, do not place
CD10 only, if replacement is necessary.
objects filled with liquids, such as vases, on the
appliance.
For customers in Canada
©2003 Sony Corporation
To prevent electric shock, match wide blade of
Printed in China
plug to wide slot, fully insert.
3-251-193-91 (1)
Power Sources
A
1
to DC IN 10V
2
to a wall outlet
Connect the AC power adaptor A.
Preparing the remote B
Insert two size AAA (R03) batteries (not supplied).
Replacing batteries
With normal use, the batteries should last for about six months. When the remote no longer
operates the player, replace two batteries with new ones.
Owner's Record
The model number and serial number are located
at the rear.
Record the serial number in the space provided
below. Refer to them whenever you call upon
your Sony dealer regarding this product.
Model No. ZS-D10
Serial No.
For customers in the USA
Please register this product on line at http://
www.sony.com/productregistration.
Proper registration will enable us to send you
periodic mailings about new product,
services and other important announcements.
Registering your product will also allow us to
contact you in the unlikely event that the
product needs adjustment or modification.
Thank you.
B