Messages - Sony Model CHC-CV40 Operating Instructions Manual

If the system still does not operate
properly after performing the above
measures, reset the system as
follows:
1
Unplug the power cord.
2
Plug the power cord back into the wall
outlet.
3
Press ?/1 to turn on the system.
4
Press x, ?/1 and ENTER at the same
time.
5
Unplug the power cord.
6
Plug the power cord back into the wall
outlet, then press ?/1 to turn on the
system.
The system is reset to the factory settings. All
the settings you made such as the preset
stations, clock and timer are cleared and must
be set again.
Note
You cannot reset the system in Power Saving Mode.

Messages

One of the following messages may appear or
flash in the display during operation.
VIDEO CD/CD/MP3 files
Cannot Edit
You tried to use Tape Select Edit for discs
containing over 20 tracks.
No Disc
There is no disc in any of DISC 1 – 3.
Cannot Use
You pressed an invalid button.
NO STEP
You have cleared all the tracks you programed.
OVER
• You have reached the end of the disc while
pressing M during play or pause.
• When fast-forwarding an MP3 file, it comes to
the end of the file.
Push STOP!
You pressed PLAY MODE/TUNING MODE
during play.
Step Full!
You tried to program 26 or more tracks (steps).
TOC Reading
The system is reading the TOC information of the
disc. Some buttons are not available.
TAPE
No Tab
You cannot record the tape because the tab has
been removed from the cassette.
No Tape
There is no tape in the tape deck.
Open
You performed a tape operation with the tape deck
lid not completely shut.
GB
39