Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Atlas Copco 2000-2/MF
Summary of Contents for Atlas Copco 2000-2/MF
- Page 2 Repair Instructions No.176.11/95 PAGE PN 2000-2/ MF/ MF2/ N/ SMF2/ spec.N Special Tools Mandril (diameter 9.5 mm), approx. 100 mm long. Required Assembly support in which the tool can be fixed vertically. Important! Before beginning the maintenance work, perform an initial check with a high voltage test according to VDE (see chapter Electrical and Mechanical Test Instructions).
- Page 3 Repair Instructions No.176.11/95 PAGE PN 2000-2/ MF/ MF2/ N/ SMF2/ spec.N Dismantling the Remove the axial needle bearing (4). reduction gear Take out the complete reduction gear, then remove the reduction gear shaft (8). Remove the needle bearing (2) and the sealing ring (1).
- Page 4 Repair Instructions No.176.11/95 PAGE PN 2000-2/ MF/ MF2/ N/ SMF2/ spec.N Dismantling the Unscrew and remove the service cover (2). handle shells Loosen the screws of the cable clip (5), remove it and lay bare the power supply lead. Loosen the connectors (4). Unscrew and remove the housing (3).
- Page 5 Repair Instructions No.176.11/95 PAGE PN 2000-2/ MF/ MF2/ N/ SMF2/ spec.N Maintenance General It is recommended to regularly submit the tool to maintenance, or as soon as the hammer mechanism gets weak, or when the carbon brushes switch off. When carrying out maintenance all parts of the maintenance set must be exchanged.
- Page 6 Repair Instructions No.176.11/95 PAGE PN 2000-2/ MF/ MF2/ N/ SMF2/ spec.N Assembly Mounting the Insert the armature (4) together with the armature field (5) into the housing. Only applicable for PN 2000 SMF2: nsert the complete switch (6), with the torque pre-setting dial and the torque switch into the housing.
- Page 7 Repair Instructions No.176.11/95 PAGE PN 2000-2/ MF/ MF2/ N/ SMF2/ spec.N Mounting the Mount the needle bearing (1). cylinder Insert the sealing ring (6). Insert the snap die (2), the rubber ring, the washer, the spring ring, and the drill spindle (5).
- Page 8 Repair Instructions No.176.11/95 PAGE PN 2000-2/ MF/ MF2/ N/ SMF2/ spec.N Mounting the Insert the spindle sleeve (9) into the gear gear box box. Fit the gear wheel (1). Insert the O-ring (3) together with the discs. Mount the gear switch lever (7) and the pin (8).
Need help?
Do you have a question about the 2000-2/MF and is the answer not in the manual?
Questions and answers