Sony SNC-DP10 User Manual page 27

To obtain the IP address automatically from a
DHCP server:
Select Obtain an IP address automatically.
The IP address, Subnet mask and Default gateway
are assigned automatically.
To specify the IP address manually:
Select Use the following IP address, and type the
IP address, Subnet mask and Default gateway in the
relevant boxes.
Note
When you select Obtain an IP address
automatically, make sure that the DHCP server is
operating on the network.
8
Set the DNS server address.
To obtain the DNS server addresses
automatically:
Select Obtain DNS server address automatically.
To specify the DNS server addresses manually:
Select Use the following DNS server address, and
type the Primary DNS server address and
Secondary DNS server address in the relevant
boxes.
Note
The Third DNS server address and Fourth DNS
server address are invalid for this camera.
9
Set the HTTP port No.
Normally, select 80 for the HTTP port No. To use
another port number, type the port number between
1024 and 65535 in the text box.
10
Type the Administrator name and Administrator
password.
The factory settings of both items are "admin."
Note
You cannot change the Administrator name and
Administrator password in this step. To change
these items, see "Setting the User — User setting
Page" on page 21.
11
Confirm that all items are correctly set, then click
OK.
If "Setting OK" is displayed, the IP address is
correctly assigned.
12
To access the camera directly, double-click the
camera name in the list.
The welcome page of the network camera is
displayed on the web browser.
Using the Supplied Setup Program
27