Changing The Communication Bandwidth; Setting The Date And Time - Sony SNC-DP10 User Manual

Note
If the IP address is not set correctly, the welcome page
does not appear after step 12. In that case, try to set the
IP address again.
Changing the Communication
Bandwidth
1
Click the Bandwidth control tab to display the
bandwidth setting window.
The current bandwidth is displayed in Current
bandwidth.
2
Click to select the desired bandwidth from the
Setting bandwidth list box.
3
Type the Administrator name and Administrator
password in each box.
4
Click OK.
If "Setting OK" is displayed, the bandwidth setting
is completed.
Note
The contents of the bandwidth changed in "IP Setup
Program" are reflected to Bandwidth control in the
Network setting page (page 20).
28
Using the Supplied Setup Program

Setting the Date and Time

You can set the date and time on this unit.
1
Click the Date time tab to display the date/time
setting window.
2
Click to select the SNC-DP10 you want to set the
date and time for.
3
Select the date/time format from the Date time
format drop-down list.
4
Select the area where the SNC-DP10 is installed
from the Time zone selecting drop-down list.
5
Set the date and time.
You can set the date and time in two ways.
Manual setting
Set the current date and time on the Manual current
date time setting boxes, and click OK. The setting
boxes are for the year (lower two digits), month,
date, hour, minutes and seconds from left to right.
Using the computer's date and time
The date and time set on the computer is displayed
in the PC current date time setting box.
Click OK on the right to set the date and time of
SNC-DP10 to the displayed computer's date and
time.