Jenn-Air JXL6536HSS Installation Instructions And Use & Care Manual page 11

3. Slide the upper duct covers up the frame to the ceiling, and
then secure to the upper horizontal support with 2 - 3.5 x 6.5
mm screws.
A
D
A. 3.5 x 6.5 mm screw
B. Slotted holes (2)
4. Place the long end of the plastic clips (2) into the bottom of
the front lower duct cover.
B
A. Lower duct cover - (front)
B. Plastic clips (2) (long end for front placement)
5. Install the lower duct cover (front) to the range hood canopy.
Spread the lower duct cover opening slightly and position it
over the upper duct cover. Set the lower duct cover in place.
Position so the flanges of the lower duct cover set into the
flanges of the upper duct covers.
A
A. Range hood canopy
B. Plastic clips
6. Install the lower duct cover (rear) to the range hood canopy.
Spread the lower duct cover opening slightly and position it
over the upper duct cover. Set the lower duct cover in place.
Position so the flanges of the lower duct cover set into the
flanges of the upper duct cover. Make sure the front and rear
lower duct covers mate properly.
B
C
C. Upper duct covers
D. Ceiling
A
D
C
B
C. Lower duct covers
D. Upper duct covers
NOTE: When assembling the rear lower duct cover to the
front lower duct cover, the flange (both sides) must be placed
over the plastic clip to secure the lower duct covers together
at the bottom.
A
B
C
A. Lower duct cover (rear)
B. Plastic clips
7. Secure the lower duct covers together at the top using
plastic clips (2). Use one plastic clip on each side.
A
A. Plastic clips (2)
B. Lower duct covers top clip area
D
C. Lower duct covers
D. Upper duct covers
B
11