Connect The Speakers - Sony CMT-SE9 Operating Instructions Manual

1 Connect the speakers.

Be sure to match the appropriate speaker
cords from the speaker terminals to the
corresponding SPEAKER terminals on the
DVD player.
Connect Terminal
Front speakers SPEAKER FRONT
L (white)/R (red)
Surround SPEAKER SURR L (blue)/
speakers R (gray)
Center speaker SPEAKER CENTER (green)
Subwoofer SPEAKER WOOFER
(purple)
Speakers
Black (#)
Black (#)
Notes
• When inserting the speaker cord plugs into the
SPEAKER terminals on the DVD player, press in the
plugs all the way until they click. When unplugging
the speaker cords, press the protrusions on the plugs
and pull out the plugs.
• Keep the speaker cords away from the antennas to
prevent noise.
• Do not place the surround speakers on top of a TV.
This may cause distortion of the colors in the TV
screen.
• Be sure to connect both left and right surround
speakers. Otherwise, the sound will not be heard.
Tip
When positioning the front speakers higher than floor
level, using the speaker stand WS-MC1 (not supplied)
is convenient.
2 Connect the FM and AM antennas.
Set up the AM loop antenna, then connect
it.
AM loop antenna
Extend the FM lead antenna horizontally
3 Connect the audio cords.
Connect to the corresponding letter jack (A,
B) in the order indicated on the rear panel.
Match the jack and plug colors, and insert
the plugs firmly all the way.
4 Connect the digital optical cables.
Connect to the corresponding letter jack (C,
D) in the order indicated on the rear panel.
Gray (3)
5 Connect the system control cable to
Gray (3)
the SYSTEM CONTROL connectors on
the DVD player.
Note
The system cable is used to send signals and electricity
between the DVD player and MD deck for interlinked
operation.
Be sure to insert the connector until it clicks into place.
Otherwise the system will not operate correctly.
continued
GB
9