Listening To The Radio; Preset Tuning - Sony CMT-EX200 Operating Instructions Manual

Presetting radio stations (continued)
To stop scanning
Press TUNING MODE on the remote.
To tune in a station with a weak
signal
Press TUNING MODE on the remote
repeatedly in step 2. "MANUAL" appears.
Then press TUNING – or + (or – or + on the
remote) repeatedly to tune in the station
manually and continue from step 4.
To change the preset number
Start over from step 1.
To change the AM tuning interval
The AM tuning interval is factory-set to 9 kHz
(10 kHz in some areas). To change the AM
tuning interval, tune in any AM station first,
then turn off the system. While holding
TUNING + on the system, turn the system back
on. When you change the interval, all the AM
preset stations are erased. To reset the interval,
repeat the same procedure.
Tips
• The preset stations are retained for about a week
even if you disconnect the power cord or if a power
failure occurs.
• When a new station is memorized, the station
formerly memorized at that preset number is erased.
14

Listening to the radio

— Preset Tuning

Preset radio stations in the tuner's memory first
(see "Presetting radio stations" on page 13).
1
Press TUNER/BAND (or TUNER BAND
on the remote) repeatedly to select
"FM" or "AM".
2
Press TUNING MODE on the remote
repeatedly until "PRESET" appears.
3
Press . or > to select the desired
preset station.
Listening to non-preset radio
stations
• Press TUNING MODE on the remote
repeatedly in step 2. "MANUAL" appears.
Then press TUNING – or + (or – or + on the
remote) repeatedly to tune in the desired
station (Manual Tuning).
• Press TUNING MODE on the remote
repeatedly until "AUTO" appears in step 2
then press TUNING – or + (or – or + on the
remote). The frequency indication changes
and the scanning stops when the system
tunes in a station (Automatic Tuning).
To cancel Automatic Tuning
Press TUNING MODE on the remote.
Tips
• If noise is heard while listening to an FM station,
remove the FM antenna from the rear panel and
place the antenna outside the cabinet.
• To improve broadcast reception, adjust the supplied
antennas, or connect a commercially available
external antenna.
• When an FM stereo program has static noise, press
FM MODE on the remote repeatedly until
"MONO" appears. There will be no stereo effect,
but the reception will improve.