Declaration Of Compliance To Norms; Work Station Safety - Technifor UC500 Operating And Maintenance Manual

Declaration of compliance to norms

The equipment is compliant with the following norms:
• Standard NF EN 61000-6-2 of January 2006 concerning electromagnetic compatibility (EMC) - Part 6-2: generic
standards- Immunity for industrial environments.
• Standard NF EN 61000-6-4 of March 2007 concerning electromagnetic compatibility (EMC) - Part 6-4: generic
standards- Standard on emissions for industrial environments.
The modification or transformation of this equipment, adaptation and accessory
installation unrecommended by Technifor, integration, piloting by a command device,
connection to an external peripheral, modify this equipment's characteristics and
therefore void the compliance with the applicable EU directives. These modifications
void Technifor's liability. In this case, the machine and equipment installer is
responsible for the final work station's compliance.

5. Work station safety

To ensure security and productivity, read this manual before starting-up the equipment.
Instructions for use and warranty limitations
• This marking equipment is designed to function at a room temperature between 5
• Position the Control Unit horizontally, in a dry, ventilated area, at least 20 cm (7.874 in) from the floor.
• The CCU's heat sink device must be located more than 3 cm (1.181 in) of any obstacle.
• Never unplug a cable while the Control Unit is turned on.
• Grounding must be done according to the regulations in effect to ensure the safety of the personnel.
• Do not use this marking equipment in an explosive environment.
This Control Unit is exclusively used to operate Technifor marking heads. If used for other purposes, Technifor
does not guarantee the quality of the results obtained. Technifor is not responsible for the damage the CCU may
cause in case of inappropriate use.
Technifor will not be held responsible for injuries resulting from disregard for the above operating instructions or
other general safety rules applicable to the use of this equipment. Furthermore, disregard for the instructions will
void the warranty.
Ref. DCD01/3067 - UC500_en_D
Introduction
A
0 0 0
C (41 F) to 45 C (113
A
0
F).
5/27