Timing Diagrams Of The Communication Signals - Technifor UC500 Operating And Maintenance Manual

Timing diagrams of the communication signals

Operating mode with the internal program T05
Launch a "Start cycle"
Stop the cycle
Obtain the "End of cycle" information
Remarks
• Pause:
Whatever the mode selected: when marking is interrupted, the "Marking ready" signal returns to phase 1. Other
signals are not modified.
• Fault:
Whatever the mode selected: if failure occurs (origin or EM machine temperature failures), the "Fault" signal goes
to phase 1. The other signals return to phase 0 until operator acknowledgement.
• In-process mode:
Impulse
Start cycle
Information
Marking in progress
Ready to marking
Ref. DCD01/3067 - UC500_en_D
Communication
A
Close the dry contact between pins 4 and 5.
Open the dry contact (usually closed) between pins 9 and 5.
Depending on the mode selected
Marking
Marking
File loaded
End of marking
cycle
Marking
C
15/27