Necessary Repairing Tools - Makita DVC260 Technical Information

R
epair
CAUTION: Repair the machine in accordance with "Instruction manual" or "Safety instructions".
Index

1 NECESSARY REPAIRING TOOLS

2-1. Removing Harness
2-2. Replacing Motor and Fan 94
2-3. Disassembling/Assembling of Upper Housing
2-4. Replacing/Cleaning of Rear Block Filter
Circuit Diagram
Wiring Diagram
3 TROUBLESHOOTING
1 NECESSARY REPAIRING TOOLS
Code No. Description
1R402-A Digital tester
- No.1 Phillips screwdriver
- No.2 Phillips screwdriver
- Slotted screwdriver
- Slotted bit 10
2 DISASSEMBLY/ASSEMBLY
2-1. Removing Harness
Fig. 2-1-1
[2]-2. Replacing Motor and Fan 94
Fig. 2-2-1
(1) Remove Harness as shown in [2]-1.
(2) Remove Lower housing complete by unscrewing
eight 4x18 Tapping screws as shown below.
Lower housing complete
checking Controller
press-fitting Ball bearing 6000DDW
press-fitting Ball bearing 6901DDW/6001DDW
removing Ball bearing 6803ZZ
removing Carrier complete
(1) Pull up Back pad of Harness and
remove six M5 + Flat head screws.
The other three screws
are on the opposite side.
Fig. 2-2-2
4x18 Tapping screw
(8 pcs)
2 / 11
P 2
P 2
P 2-7
P 8-12
P 13-14
P 25
P 26-30
P 31-33
Use for
Fig. 2-1-2
(2) Remove Harness.
(3) Lift up and take Motor section out of Upper housing
complete.
Upper housing complete
Motor section
(4) Separate Motor section from Upper housing
complete by disconnecting two Connectors.
Connectors