Makita DVC260 Technical Information page 4

Fig. 2-2-10
Note 4. When handling or storing multiple Rotors,
be sure to keep a proper distance between Rotors.
Because Rotor is a strong magnet, failure to follow
this instruction could result in:
• Finger injury from being pinched between Rotors
• Magnetic loss of Rotors or damage to Rotors.
Fig. 2-2-11
Note 5. When inserting Rotor into Stator:
・ While pushing Stator against a workbench, insert Rotor straight into Stator.
・ Do not pinch your finger between Rotor and Stator.
・ Once Rotor has been inserted, do not force
it into Stator any further or you will break
the printed wiring board of Controller B.
Rotor
[2]-3. Disassembling/Assembling of Upper Housing
Fig. 2-3-1
Replacement of Seal
Remove Seal from Dust box cover to replace it.
When assembling, match the shape of Seal with that
of the rib and then fit Seal over the rib, ensuring that
it is correctly located along its entire circumference.
Seal
Fig. 2-3-3
Removing Dust Box Cover
Open Dust box cover, then enlarge the hinge portion
from the inside with a slotted screwdriver and then
push Dust box cover Latch assembly to remove it
from Upper housing complete.
Slotted screwdriver
Stator
Fig. 2-3-2
Replacement of Latch Assembly
Remove Latch assembly by pushing it from the back of
Dust box cover. When assembling, fit Latch assembly in the
notches of Dust box cover and then push it from the front of
Dust box cover.
Dust box cover
Upper housing complete
Dust box cover
4 / 11
Surface damage
Inner cracks
Printed wiring board
of Controller B
Latch assembly
Dust box cover
Fig. 2-3-4
Installing Dust Box Cover
Set Dust box cover in the position where it was when
you had just removed it and then push it onto Upper
housing complete.
Upper housing complete
Magnetic loss
A correctly assembled
Motor section
will fit in Housing R snugly.
Dust box cover