Advertisement
R
epair
CAUTION: Repair the machine in accordance with "Instruction manual" or "Safety instructions".
[1] NECESSARY REPAIRING TOOLS
Code No.
Description
782209-3 Socket wrench 9 Removing/ tightening M5x10 Hex flange head bolt
[2] DISASSEMBLY/ASSEMBLY
[2]-1. Fan 86
DISASSEMBLING
Remove Fan 86 as illustrated in Fig. 1.
Note: 1) Separate Front cover complete from Fan cover first, because there is a 4x75 Tapping screw to fasten Fan cover
under Front cover complete.
2) Blow away the remaining dust in Motor housing set when disassembling it.
Fig. 1
1. Remove Front cover complete and 4x18 Tapping screws.
Pin 4 comes into sight as illustrated below.
Note: Do not turn over the machine without removing Pin 4
from Motor housing set.
Pin 4
4x18 Tapping
screws (3pcs.)
Front cover complete
3. Cap 19 illustrated below is easy to fall off
Motor housing set.
Therefore, remove it in advance.
5. Fan 86 can be removed with Flat washer 10
attached on the reverse.
Note: Flat washer 10 may fall off Motor shaft,
or may be left on.
Do not miss it.
Use for
Fan cover
Motor housing set
4x75 Tapping
screw (3pcs.)
Cap 19 hooked with
the notch of Motor
housing set
Flat washer 10
2. Remove Pin 4, two 4x18 Tapping screws and three
4x75 Tapping screws, and then separate Fan cover
from Motor housing set.
Fan 86 comes into sight.
4x18 Tapping screw (2pcs.)
Fan cover
4. While holding Fan 86 by gloved hand,
remove Max Hex flange head bolt by
turning Socket wrench 9 counterclockwise.
Socket wrench 9
Fan 86
P 2/ 7
Joint
Cap 19
Pin 4
Seal ring
Advertisement
