Makita DVC260 Technical Information page 9

Wiring Diagram
Fig. D-4
In Upper and Lower Housing
Fix Lead wires (orange, white, blue)
from Stator in this Lead wire holder.
Upper housing complete
Put Fuse in
this space.
Fuse
Terminal A
Route Power supply cord unit
through this groove.
Power supply cord unit
Wire connecting portion
Flag connector
Fix Lead wires (red, blue, yellow, white, black)
from Controller B in this Lead wire holder.
Rib D
The Flag connector must be so connected
that its wire connecting portion is located
over the mark of + - poles.
Terminal A
Put Connectors in place as shown below.
Do not route any Lead wires over Connectors.
Rib B
Boss Rib C
Route the following Lead wires of Controller A
between Ribs B and C and between Rib D and Boss:
• (black, yellow, red) to Terminal A
• (red, blue, yellow, white, black) to Controller B
• (orange, white, blue) to Stator
Terminal B
9 / 11
Motor assembly
(Stator, Rotor,
Controller B)
Controller A
Rib A
Capacitor
Put Controller A in this
space with Capacitor
on Rib A side.
Terminal B