Operating Modes - Sullair ShopTek User Interface Manual

SECTION 4
since the last service.
FLUID – Displays the total time on the fluid since the
last service.
GREASE – Displays the total time on the grease
since the last service.
ALARM1, ALARM2, ALARM3, ALARM4, ALARM5
– Displays past alarms or faults.
description along with the number of hours on
machine when the alarm or fault occurred.
PRODUCTION DATE – Displays production date of
compressor.
SERIAL NO. – Displays serial number of machine.
CUSTOMER SET
PARAMETERS
The Customer Set View shows current machine
parameters which are conditions and limits that can
be modified by the operator. This view is accessed
using the navigational arrows and is indicated by the
text "CUSTOMER SET" appearing on the first line of
the display screen. The second line of the display
screen indicates "FACTORY SET".
factory settings which cannot be changed by the end
user without the factory password. Press the Right
arrow pad when "CUSTOMER SET" appears
as reverse characters on the display screen. From
here, the parameters are displayed and can be
changed. Refer to Section 3: Adjustments for
instructions on changing the compressor control
parameters and a list of the control parameters that
can be modified by the user.
CUSTOMER SET
FACTORY SET
Figure 4-5: Accessing Customer Set View
4.5

OPERATING MODES

The Operating Mode is the manner in which the
machine operation is being controlled.
There are four Operating Modes: AUTOMATIC,
MANUAL, STOP, and FAULT. The active operating
mode of the compressor appears on the upper line of
the display screen's Normal View. See Figure 4-6.
S T
HOP
Displays the
VIEW – CONTROL
These are
02250180-094 R00
CONTROLLER USER INTERFACE MANUAL
™
EK
Automatic Mode
(Normal View)
Figure 4-6: Compressor Operating Mode Display
The compressor operating modes are described
below:
Automatic mode - Indicated by the word AUTO
appearing in the upper line of the display window.
This is a user selected mode that sets the
compressor motor to automatically start when
conditions necessitate
operation not required.
Manual Mode - Indicated by the word MANUAL
appearing in the upper line of the display window.
This is a user selected mode that allows the operator
to manually control the compressor motor operation.
When the START
Manual Mode the compressor motor will run
continuously until the STOP
The compressor and all other machine parameters
function the same in both Manual and Automatic
modes.
Stop mode - Indicated by the word STOP
appearing in the upper line of the display window.
This mode indicates that the compressor and motor
have been turned off under normal conditions. When
in this mode the machine will not operate until the
START pad is pressed. If the machine is stopped
due to the E-Stop button being pressed, this is
indicated by the word E-STOP appearing in the
upper line of the display window.
Fault mode - Indicated by the word STOP appearing
in the upper line of the display window along with a
fault code on the lower line. This mode indicates that
a machine problem has occurred causing the
controller to shut down the machine until the
condition is cleared. After a fault condition has been
resolved, the fault indication can be cleared from the
controller by pressing and holding the Return/Reset
pad. Refer to Section 5: Troubleshooting, for
information on resolving fault conditions.
AUTO LOAD
174°F 62PSI
and stop when
pad is pressed while in
pad is pressed.
motor
25