7: Calibrating The Appropriate Settings Automatically (Auto Calibration) - Sony STR-DG510 Operating Instructions Manual

7: Calibrating the
appropriate settings
automatically
(AUTO CALIBRATION)
The DCAC (Digital Cinema Auto Calibration)
function allows you to perform automatic
calibration such as:
• Checking the connection between each
speaker and the receiver.
• Adjusting the speaker level.
• Measuring the distance of each speaker from
your listening position.
You can also adjust the speaker levels and
balance manually. For details, see
"8: Adjusting the speaker levels and balance
(TEST TONE)" (page 31).
Before you perform Auto
Calibration
Before you perform Auto Calibration, install
and connect the speakers (page 14, 15).
• The AUTO CAL MIC jack is used for the
supplied optimizer microphone only. Do not
connect other microphones to this jack.
Doing so may damage the receiver and the
microphone.
• During calibration, the sound that comes out
of the speakers is very loud. Pay attention to
the presence of children or to the effect on
your neighborhood.
• Perform Auto Calibration in a quiet
environment to avoid the effect of noise and
to get a more accurate measurement.
• If there are any obstacles in the path between
the optimizer microphone and the speakers,
the calibration cannot be performed
correctly. Remove any obstacles from the
measurement area to avoid measurement
error.
28
GB
Notes
• The Auto Calibration function does not work when
headphones are connected.
• Make sure SPEAKERS (OFF/A/B) is not set to off.
?/1
MASTER VOLUME
DISPLAY INPUT MODE
INPUT SELECTOR
SPEAKERS
(OFF/A/B)
AUTO CAL MIC
MEMORY/ TUNING
ENTER MODE TUNING 2CH A.F.D. MOVIE MUSIC AUTO CAL
PHONES
1
Connect the supplied optimizer
microphone to the AUTO CAL
MIC jack.
2
Set up the optimizer
microphone.
Place the optimizer microphone at your
listening position.You can also use a stool
or tripod so that the optimizer
microphone remains at the same height as
your ears.
Optimizer microphone
DIRECT