Performing Auto Calibration - Sony STR-DG510 Operating Instructions Manual

Performing Auto Calibration

TV INPUT AUTO TV ?/1
SLEEP CAL AV ?/1
1
VIDEO 1 VIDEO 2 VIDEO 3
SAT TV SA-CD/CD TUNER
2CH A.F.D.
1 2
4 5
7 8
MEMORY DVD MENU
>10/
-
0/10
CLEAR
DISPLAY
F
G
f
RETURN/EXIT
1
Press AUTO CAL.
Measurement starts in 5 seconds and the
display changes as follows:
A.CAL [5] t A.CAL [4] t A.CAL [3]
t A.CAL [2] t A.CAL [1]
While the time is counting down, stand
away from the measurement area to avoid
measurement error.
?/1
?/1
switch
SYSTEM STANDBY
DVD
Input
buttons
MOVIE MUSIC
AMP MENU
3
FM MODE
6
D.TUNING
9
D.SKIP
ENTER
MUTING
TOOLS
MUTING
TV VOL
MASTER VOL
g
MASTER
VOL +/–
MENU
2
Measurement starts.
The measurement process will take a few
minutes to complete.
The table below shows the display when
measurement starts.
Measurement for Display
Environment noise
level
Speaker connection MEASURE and SP
Speaker level
Speaker distance
* The corresponding speaker indicator lights
up in the display during measurement.
3
Measurement ends.
"COMPLETE" appears on the display
and the settings are registered.
4
Disconnect the optimizer
microphone from the AUTO
CAL MIC jack.
Note
Auto Calibration cannot detect the sub woofer.
Therefore, all sub woofer settings will be
maintained.
Tip
During the measurement process, Auto Calibration
is canceled when you do the following.
– Press ?/1, input buttons or MUTING.
– Change the volume level.
– Press AUTO CAL again.
NOISE.CHK
DET. appears
alternately*
MEASURE and GAIN
appears alternately*
MEASURE and
DISTANCE appears
alternately*
29 GB