Remote Settings - Fluke 8588A Operator's Manual

8588A/8558A
Operators Manual

Remote Settings

The Remote Settings menu shows a list of parameters for the remote interface.
From the Instrument Setup menu, push  (Remote Settings) to use the
Remote Settings submenu. See Table 23.
See the Remote Programmer's Manual for details of setting up and using the
remote interfaces.
Menu Parameter
Emulation
Active Port
GPIB Address
Ethernet
100
Table 23. Remote Settings Submenu
The Product remote interface can emulate the Fluke 8508A () or the
HP/Agilent/Keysight 3458A () digital multimeters. If  (None) is
selected, the Product uses its native SCPI commands.
To choose the active remote port, use the navigation keys to move the cursor
to highlight the active-port field. The choice are:
•
 (GPIB)
•  (Ethernet)
•  (USB)
To change the GPIB Address, use the navigation keys to highlight the GPIB
Address field and then use the numerical keys to change the address. When
done, push  to store the address.
To change the Ethernet settings, use the navigation keys to highlight the
Ethernet Settings field, push  and then use the navigational keys,
softkeys, and numerical keys to change the settings. You can change DHCP,
Ethernet IP Address, Gateway, Subnet Mask, Port, Remote IF, and EOL.
Change the Parameter