Fujitsu LifeBook S Series Manual page 85

System BIOS shadowed
System BIOS copied to shadow RAM.
*System CMOS checksum bad – run SETUP
BIOS CMOS RAM has been corrupted or
modified incorrectly, perhaps by an application
program that changes data stored in BIOS
memory. Run Setup and reconfigure the system.
*System RAM Failed at offset: nnnn
System memory failed at offset nnnn of in the
64k block at which the error was detected. This
means that there is a fault in your built-in memory.
If you continue to operate, you risk corrupting
your data. Contact your support representative
for repairs.
nnnn System RAM Passed
Where nnnn is the amount of system memory in
kilobytes successfully tested.
*System timer error
The timer test failed. The main clock that operates
the computer is faulty. Requires repair of system
board. Contact your support representative for
repairs. UMB upper limit segment address: nnnn
Displays the address of the upper limit of Upper
Memory Blocks, indicating released segments of
the BIOS memory which may be reclaimed by a
virtual memory manager.
Video BIOS shadowed
Video BIOS successfully copied to shadow RAM.
EMERGENCY OPTICAL DRIVE TRAY
RELEASE
If for some reason the eject button fails, you can
open the optical drive tray with a paper clip or
similar tool inserted into the eject hole in the far
right side of the front of the tray. Straighten one
side of a paper clip and push it gently into the
hole. The tray will pop out a short distance.
LB_GARLICS 05 (57-74)
MODEM RESULT CODES
The operating system and application software
that is factory installed detects the modem
characteristics and provides the necessary
command strings to operate the modem. The
internal modem operation is controlled by generic
AT commands from the operating system and
application software. The standard long form
result codes may, in some cases, be displayed
on your screen to keep you informed of the
actions of your modem. The operating system
and application software may suppress display
of the result codes.
Examples of result codes are:
• OK
• NO CARRIER
• NO DIALTONE
• CONNECT 53000 (Connection complete at
• ERROR
• FAX
• RING (This means an incoming call.)
• BUSY
• NO ANSWER
When using the internal modem with applications
that are not factory installed refer to the
application documentation.
73
Tr o u b l e s h o o t i n g
CD eject button
53,000 bps.)
21/7/03, 6:27 PM
73