Infrared Port; Headphone Jack; Microphone Jack - Fujitsu LifeBook S Series Manual

L i f e B o o k S S e r i e s - S e c t i o n 4
The IEEE 1394 por t on your LifeBook
notebook is a 4-pin type. If you want to
connect a 6-pin device, you will need to
purchase a 4-pin to 6-pin adapter cable.
In order to connect an IEEE 1394 device, follow
these steps:
1. Align the connector with the port opening.
2. Push the connector into the port until it is
seated.
Figure 4-22. Connecting an IEEE 1394
Device

INFRARED PORT

The IrDA infrared (4Mbps) port allows for wireless
data transfer between your notebook and other
IrDA-compatible devices, such as another
computer or a printer, without the use of a cable.
It is important to keep in mind that while carrying
out this form of communication, both devices
must be placed so their infrared ports are directly
facing each other without obstruction. The
devices must also be separated by at least 6"
but no more than 36" for maximum performance.
The following conditions may interfere with
infrared communications:
• A television, radio remote control unit, or a
wireless headphone is being used nearby.
• Direct sunlight, fluorescent light, or
incandescent light shines directly on the port.
54
LB_GARLICS 04 (48-56)
Do not move either device while
communication is active as it may
interrupt data transmission.
Be careful not to scratch the infrared port
lens. Dirt, scratches, or other surface
marks can degrade operation.

HEADPHONE JACK

The headphone jack allows you to connect
headphones or powered external speakers to
your notebook. Your headphones or speakers
must be equipped with a 1/8" (3.5 mm) stereo
mini-plug. In order to connect head-phones or
speakers follow these easy steps:
1. Align the connector with the port opening.
2. Push the connector into the port until it is
seated.
If you plug headphones into the headphone
jack, the built-in stereo speakers will be
disabled.

MICROPHONE JACK

The microphone jack allows you to connect an
external mono microphone. Your microphone
must be equipped with a 1/8"(3.5 mm) mono mini-
plug in order to fit into the microphone jack of
your notebook. In order to connect a microphone
follow these easy steps:
1. Align the connector with the port opening.
2. Push the connector into the port until it is
seated.
54 21/7/03, 6:26 PM