Fujitsu LifeBook S Series Manual page 76

L i f e B o o k S S e r i e s - S e c t i o n 5
Problem
PC Card Problems
A card inserted in
the PC Card slot
does not work or is
locking up the
system.
Power Failures
You turn on your
LifeBook notebook
and nothing seems
to happen.
64
LB_GARLICS 05 (57-74)
Possible Cause
The card is not properly
installed.
The card may have been
installed while an
application was running,
so your notebook is not
aware of its installation.
Your software may not
have the correct software
driver active.
You may have the wrong
I/O address selected for
your PC Card activated or
not install.
Your PC Card device and
another device are
assigned the same I/O
address.
The installed primary
battery is completely
discharged, there is no
optional second battery
installed or there is no
Power adapter (AC
adapter) installed.
The primary battery is
installed but is faulty.
The battery or batteries
are low.
The power adapter (AC
adapter) is not plugged
in properly.
64
Possible Solution
Remove and re-install the card.
Close the application and restart your
notebook.
See your software documentation and activate
the correct driver.
See your PC Card documentation to
determine the required I/O address. Change
the settings in the BIOS.
Check all I/O addresses located within the
BIOS setup utility and any other installed
hardware or software to make sure there are
no duplications.
Check the Status Indicator Panel to determine
the presence and condition of the batteries.
Install a charged battery or a power adapter.
Use the Status Indicator Panel to verify the
presence and condition of the batteries. If a
battery is indicating a short, remove that
battery and operate from another power
source or replace that battery.
Check the Status Indicator Panel to determine
the presence and condition of the batteries.
Use a power adapter to operate until a battery
is charged or install a charged battery.
Verify that your adapter is connected correctly.
21/7/03, 6:26 PM