Fujitsu LifeBook S Series Manual page 79

Problem
Shutdown and Startup Problems
The Power
Suspend/Resume
button does not
work.
The system
powers up and
displays power-on
information, but
fails to load the
operating system.
An error message
is displayed on the
screen during the
notebook (boot)
sequence.
LB_GARLICS 05 (57-74)
Possible Cause
The Power/Suspend/
Resume button is disabled
from the Advanced
submenu of the Power
Options menu.
You did not hold the
button in long enough.
There may be a conflict
with the application
software.
The boot sequence
settings of the setup utility
are not compatible with
your configuration.
You have a secured
system requiring a
password to load your
operating system.
Internal hard drive was
not detected.
Power On Self Test
(POST) has detected a
problem.
67
Tr o u b l e s h o o t i n g
Possible Solution
Enable the button from the setup utility.
Hold the button longer. This may need to be a
few seconds if your application is preventing
the CPU from checking for button pushes.
Close all applications and try the button again.
Set the operating source by pressing the
[ESC] key while the Fujitsu logo is on screen
or use the [F2] key and enter the setup utility
and adjust the source settings from the Boot
menu.
Make sure you have the right password. Enter
the setup utility and verify the Security settings
and modify them as accordingly.
Use the BIOS setup utility or Primary Master
submenu, located within the Main menu, to try
to auto detect the internal hard drive.
See the Power On Self Test (POST) messages
to determine the meaning and severity of the
problem. Not all messages are errors; some
are simply status indicators.
21/7/03, 6:26 PM
67