Serial Port; Ps/2 Port; Docking Port; Universal Serial Bus Ports - Fujitsu LifeBook E8000 User Manual

Figure 4-14. Connecting a Parallel Device

SERIAL PORT

The serial port, or COM port, located on the system and
on the optional Port Replicator allows you to connect
serial devices, such as printers or scanners. In order to
connect a serial interface device follow these easy steps:
1. Align the connector with the port opening.
2. Push the connector into the port until it is seated.
3. Tighten the two hold-down screws, located on each
end of the connector.

PS/2 PORT

The PS/2 port located on the system and on the optional
Port Replicator allow you to connect an external
keyboard or mouse. In order to connect a PS/2 interface
device follow these easy steps:
1. Align the connector with the port opening.(Figure 4-
15)
2. Push the connector into the port until it is seated.
A mouse or keyboard may be installed and
automatically recognized by your note-
book without restarting or changing set-
ups.
Figure 4-15. Connecting a PS/2 Device

DOCKING PORT

The docking port is used for the connection of your
notebook to an optional port replicator or docking
station. In order to connect your notebook to one of
these devices follow the instructions that came with your
docking port. (See figure 2-8 on page 11 for location)
U s e r I n s t a l l a b l e F e a t u r e s

UNIVERSAL SERIAL BUS PORTS

The Universal Serial Bus 2.0 ports (USB) allow you to
connect USB devices such as external game pads,
pointing devices, keyboards and/or speakers.
In order to connect a USB device follow these steps:
1. Align the connector with the port opening.(Figure 4-
16)
2. Push the connector into the port until it is seated.
Due to the ongoing changes in USB tech-
nology and standards, not all USB devices
and/or drivers are guaranteed to work.
Figure 4-16. Connecting a USB Device

INFRARED PORT

The Infrared IrDA (4Mbps) port allows for wireless data
transfer between your notebook and other IrDA-
compatible devices, such as another computer or a
printer, without the use of a cable. (See figure 2-4 on
page 7 for location)
It is important to keep in mind that while carrying out
this form of communication, both devices must be
placed so their infrared ports are directly facing each
other without obstruction. The devices must also be
separated by at least 6" but no more than 36" for
maximum performance.
The following conditions may interfere with infrared
communications:
A television, radio remote control unit, or a wireless
■
headphone is being used nearby.
Direct sunlight, fluorescent light, or incandescent light
■
shines directly on the port.
Do not move either device while com-
■
munication is active as it may interrupt
data transmission.
■ Be careful not to scratch the infrared
port lens. Dirt, scratches, or other sur-
face marks can degrade operation.
49