Programming The Remote - Sony STR-DA3200ES Operating Instructions Manual

Programming the remote

You can customize the remote to match the
components connected to your receiver. You
can even program the remote to control non-
Sony components and also Sony components
that the remote is normally unable to control.
The procedure below uses as an example a
case in which the other manufacturer's VCR is
connected to the VIDEO 2 jacks on the
receiver.
Before you begin, note that:
– You cannot change the settings of PHONO.
– The remote can control only components
that accept infrared wireless control signals.
Be sure to turn on the receiver and
point the remote towards the
receiver when performing the
following procedure.
1
2
3
108
GB
1
Press AV ?/1 while pressing RM
SET UP.
The RM SET UP button flashes.
2
While the RM SET UP button is
flashing, press the input button
(including TV) for the
component you want to control.
For example, if you are going to control a
CD player, press SA-CD/CD.
The RM SET UP button and input button
flash.
3
Press the numeric buttons to
enter the numeric code (or one
of the codes if more than one
code exists) corresponding to
the component and the maker
of the component you want to
control.
The RM SET UP button and input button
light up.
Note
For a TV remote code value, only numbers in
the 500's are valid.
4
Press ENTER.
Once the numeric code has been verified,
the RM SET UP button flashes twice and
the remote automatically exits the
programming mode. The input button
also turns off.
To cancel programming
4
Press RM SET UP during any step.