4
Point the remote code receiver
section of the remote toward
the receiver/transmitter on the
remote control to be learned
from.
While the second remote is receiving the
signal, the input button selected in step 2
turns off.
About 5 cm - 10 cm (2" - 4")
5
The RM SET UP button flashes
twice, then the learning
process is completed.
When the learning process fails, the RM
SET UP button flashes five times. Try to
perform process again from step 2.
6
Press RM SET UP to finish the
Learning function process.
Tips
• When the memory capacity for storing remote
control codes reaches a certain limit, the RM SET
UP button flashes 10 times, and then the learning
process ends.
• If the RM SET UP button flashes five times in step
1, and the learning process does not start, replace
the batteries with new ones.
To cancel learning
Press RM SET UP. Also, not pressing any
button for 60 seconds cancels the settings.
GB