Activation Via Sadp Software - HIKVISION DY5 Series Quick Start Manual

3.2.2 Activation via SADP Software

SADP software is used for detecting the online device, activating the device, and
resetting the password.
Get the SADP software from the supplied disk or the official website, and install the
SADP software according to the prompts.
Follow the steps to activate the positioning system.
Steps:
1. Run the SADP software to search the online devices.
2. Check the device status from the device list, and select an inactive device.
Note:
The SADP software supports activating the positioning system in batch. Refer to the
user manual of SADP software for details.
3. Create a password and input the password in the password field, and confirm the
password.
STRONG PASSWORD RECOMMENDED– We highly recommend you create a
strong password of your own choosing (using a minimum of 8 characters,
including upper case letters, lower case letters, numbers, and special
characters) in order to increase the security of your product. And we
recommend you reset your password regularly, especially in the high security
system, resetting the password monthly or weekly can better protect your
product.
Note:
You can enable the Hik-Connect service for the device during activation. Refer to
section 5.1 Enable Hik-Connect Service on Positioning System.
Hik-Connect service is not supported by certain positioning system models.
4. Click Activate to save the password.
Network Positioning System·Quick Start Guide
Select inactive device.
Figure 3-4 SADP Interface
24
Input and confirm
password.