Installation; Installing Dy9Xxx Network Positioning System; Installing Dy9Xxx Series Laser Network Positioning System (Type Iii And Type Iv) - HIKVISION DY5 Series Quick Start Manual

Network positioning system
Hide thumbs Also See for DY5 Series:
Table of Contents

Advertisement

2 Installation

Before you start:
Check the package contents and make sure that the device in the package is in good
condition and all the assembly parts are included.
Notes:
 Do not power the positioning system up until the installation is finished. To ensure
safety of personnel and equipment, all the installation steps should be done with
power supply off.
 The positioning system is much heavier than the normal camera, and it strongly
demands for load-bearing and stability of the upholder. It's highly recommended to
install the system to the upholder directly.
 If you need to install the positioning system to the bracket, refer to bottom view of
the positioning system as shown in section 1.1 Introduction to select the bracket.
The load-bearing and anti-shake capabilities must be fully taken into consideration.

2.1 Installing DY9xxx Network Positioning System

2.1.1 Installing DY9xxx Series Laser Network Positioning System (Type III
and Type IV)
Steps:
1. Fix the positioning system.
1) Fix the positioning system onto the bracket pedestal with the supplied M8*30
screws as shown in Figure 2-1 and Figure 2-2.
Network Positioning System·Quick Start Guide
Figure 2-1 Fix the Positioning System (Type III)
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dy7 seriesDy9 series

Table of Contents