HIKVISION DY5 Series Quick Start Manual page 20

Network positioning system
Hide thumbs Also See for DY5 Series:
Table of Contents

Advertisement

3) Align the buckles to the screw holes on the IR bracket and secure them with two
M4*10 screws.
Note:
The buckles are fixed with the cable by default.
2. Route the cables of IR modules.
1) Pull out the two original plugs from the housing.
2) Loosen the nuts on the water-proof cable plugs.
3) Route the IR module cables through the cable holes on the housing respectively.
4) Rotate the locking plug clockwise and tightly to the housing.
5) Insert the cables to the housing as much as possible, and fasten the water-proof
cable nuts with a wrench.
Network Positioning System·Quick Start Guide
Figure 2-13 Secure the IR Module
Figure 2-14 Secure the Cables to IR Bracket
Figure 2-15 Route the Cables
19
Locking Plug
Water-proof Cable Nut

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dy7 seriesDy9 series

Table of Contents