Table of Contents
Advertisement
4. Connect the corresponding cables and turn the power on; the system will do the
self-test automatically.
2.1.2 Installing DY9xxx Series IR Network Positioning System (Type II)
Steps:
1. Install the IR module.
1) Align the screw holes on the IR bracket with the screw holes on the housing as
shown in Figure 2-12. Insert and tighten the two M4*10 screws to secure the
bracket.
2) Loosen and remove the screws on the top of IR module. Align the screw holes on
the IR module with the screw holes on the IR bracket, and secure the IR module
to the IR bracket with the screws.
Network Positioning System·Quick Start Guide
Figure 2-11 Restore the Housing (Type IV)
Figure 2-12 Secure the IR Bracket
18
Advertisement
Table of Contents
