Vacuum Mount Installation - Gazer F121 User Manual

1
1
ENG
Fix the frame and the Fix the frame and the mount of
the device on the windshield.
mount of the device
Fix the frame and the mount of
on the windshield.
the device on the windshield.
3
3
Loosen the screw 1 by turning it
counterclockwise. Adjust the MVR
position on the frame and set the
Loosen the screw 1 by
Loosen the screw 1 by turning it
recording angle. Tighten screw 1 by
counterclockwise. Adjust the MVR
turning it counterclockwise.
turning it clockwise.
position on the frame and set the
Adjust the MVR position
recording angle. Tighten screw 1 by
turning it clockwise.
on the frame and set the
Recommendation:
recording angle. Tighten
frame right next to the rear view mirror or behind it) in the
screw 1 by turning it
position in which the lens is directed slightly downward at an Recommendation:
clockwise.
angle of about 15°. If the MVR is set too low (on the dashboard
frame right next to the rear view mirror or behind it) in the
or a bit higher), the recorded videos will not provide full
position in which the lens is directed slightly downward at an
information about the road situation as it is impossible to see the angle of about 15°. If the MVR is set too low (on the dashboard
Recommendation:
front of your vehicle. Therefore, there is no «reference point».
or a bit higher), the recorded videos will not provide full
sible (MVR frame right next to the rear view mirror or
information about the road situation as it is impossible to see the Recordings will be significantly dimmed if the device is set in
behind it) in the position in which the lens is directed
parallel with the road or at an upward angle.
front of your vehicle. Therefore, there is no «reference point».
slightly downward at an angle of about 15°. If the MVR
Recordings will be significantly dimmed if the device is set in
is set too low (on the dashboard or a bit higher), the
parallel with the road or at an upward angle.
recorded videos will not provide full information about
the road situation as it is impossible to see the front of
your vehicle. Therefore, there is no «reference point».
Recordings will be significantly dimmed if the device is
set in parallel with the road or at an upward angle.
18

Vacuum mount installation

Vacuum mount installation
Vacuum mount installation
1
1
Install your MVR as high as possible (MVR
Install your MVR as high as possible (MVR
Install your MVR as high as pos-
Install the MVR and fix the Install the MVR and fix the power
supply cable using mounting clips as
power supply cable using
shown in the drawing. Place the clips
Install the MVR and fix the power
evenly on the windshield to fix the
mounting clips as shown
supply cable using mounting clips as
cable.
shown in the drawing. Place the clips
in the drawing. Place the
evenly on the windshield to fix the
clips evenly on the wind-
cable.
shield to fix the cable.
2
2
To detach the MVR from the mount,
press tab 1. Then, holding the tab,
remove the recorder from the mount by
To detach the MVR from
To detach the MVR from the mount,
sliding it to the side 2.
press tab 1. Then, holding the tab,
the mount, press tab
remove the recorder from the mount by
1. Then, holding the tab,
sliding it to the side 2.
remove the recorder from
the mount by sliding it to
the side 2.
2
2
4
4
1
1