Drying - Belling WD14v Users Manual & Installation Handbook

Ensure that the water inlet tap is turned on.
And that the discharge tube is in place.
PROGRAMME SELECTION
Refer to the programme guide to select the most suitable
programme.
Turning the selector knob required programme is activate.
Wait for the "STOP" indicator light to flash.
Then press the START button.
When the START button is pressed the machine sets the
working sequence in motion.
The programme carries out with the programme selector
stationary on the selected programme till cycle ends.
Warning: If there is any break in the power supply while the
machine is operating, a special memory stores the selected
programme and,when the power is restored, it continues
where it left off.
At the end of the programme the indicator light "end
cycle" will go on.
When the programme has finished
Wait for the door lock to be released (about 1 minute after
the programme has finished).
Switch off the machine by turning the programme selector
to the "OFF" position.
Open the door and remove the laundry.
Turn OFF the water supply after every use.
FOR ALL TYPES OF WASH CONSULT THE PROGRAMME
TABLE AND FOLLOW THE OPERATIONS IN THE ORDER
INDICATED.
28
CHAPTER 12

DRYING

DON'T DRY GARMENTS MADE FROM FOAM RUBBER
OR FLAMMABLE MATERIALS.
IMPORTANT:
THIS DRYER CAN ONLY BE USED FOR LAUNDRY
WHICH HAS BEEN WASHED AND SPIN DRIED.
WARNING:
Indications given are general, therefore some practice is
needed for the best drying results. We recommend setting a
lower drying time than indicated, when first using, so as to
establish the degree of dryness required. We recommend
not to dry fabrics that fray easily, such as rugs or garments
with a deep pile, to avoid air duct clogging.
The water is then conveyed to the drain circuit, which is
sealed and therefore, no steam can be released outside.
29