Belling WD14v Users Manual & Installation Handbook page 10

CREASE GUARD BUTTON
The Crease Guard function minimizes creases as much as
possible with a uniquely designed anti-crease system that is
tailored to specific fabrics.
MIXED FABRICS - the water is gradually cooled throughout
the final two rinses with no spinning and then a delicate spin
assures the maximum relaxation of the fabrics.
DELICATE FABRICS – final two rinses with no spinning and then
the fabrics are left in water until it is time to unload. When you
are ready to unload, press the "Crease Guard" button – this
will drain.
WOLLENS/HAND WASH – after the final rinse the fabrics are
left in water until it is time to unload and the button indicator
blinking.
When you are ready to unload, press the "Crease Guard"
button, this will drain and spin ready for emptying.
If you do not want to spin the clothes and activate drain
only:
- Turn the programme selector to the "OFF" position;
- Select programme drain only ;
- Switch on the appliance again by pressing the
"Start/Pause" button.
18
START BUTTON
O
When a programme is selected, wait for the "STOP" indicator
light to flash before pressing the START button.
Press to start the selected cycle (according to the selected
cycle one indicator lights will go on) .
NOTE: WHEN THE START BUTTON HAS BEEN PRESSED THE
APPLIANCE CAN TAKE A FEW SECONDS BEFORE IT
STARTS WORKING.
CHANGING THE SETTINGS AFTER THE PROGRAMMES HAS
STARTED (PAUSE)
The programme may be paused at any time during the wash
cycle by holding down the "Start/Pause" button for about
two seconds. When the machine is in the paused mode, the
indicator light "Time countdown", Spin Speed and option
buttons will flash. To restart the programme, press the START
button once again.
If you wish to add or remove items during washing, wait 1
minute until the safety device unlocks the door.
When you have carried out the manoeuvre, close the door,
press START button and the appliance will continue working
from where it left off.
CANCELLING THE PROGRAMME
To cancel the programme, set the selector to the OFF position.
Select a different programme.
Re-set the programme selector to the OFF position.
BUTTON INDICATOR LIGHT
These light up when the relevant buttons are pressed.
If an option is selected that is not compatible with the
selected programme then the light on the button first flashes
and then goes off.
P
Q
19