Programming - Miele KM 6639-1 Operating And Installation Instructions

You can adapt the programming of the
hob to your personal needs. Several
settings can be altered in succession.
After accessing programming mode,
the  symbol appears and  will
appear in the timer display. After a few
seconds : (Programme 01) will flash
alternately with : (Code) in the timer
display.
Change programming
Accessing programming mode
The  sensor is located approx.
1 cm (index finger width) to the left of
the  sensor.
 With the hob switched off, touch
the  and  sensors at the same
time until the  symbol and 
appear in the timer display.
Setting a programme
For a two digit programme number
you need to first set the tens position.
 Whilst the programme is visible in the
display (e.g. :), touch
the  sensor repeatedly until the
number for the programme you want
appears in the display or touch the
appropriate number on the numerical
keybank.
Setting the code
 Whilst the code is visible in the
display (e.g. :), touch
the  sensor repeatedly until the
number for the code you want
appears in the display or touch the
appropriate number on the numerical
keybank.
To save the settings
 While the programme is showing in
the display (e. g. :) touch the 
sensor until the indicators go out.
To avoid saving the settings
 While the programme is showing in
the display (e. g. :) touch the 
sensor until the indicators go out.

Programming

51