Subscribe to Our Youtube Channel
Related Manuals for Oceanic OCS B Series
Summary of Contents for Oceanic OCS B Series
- Page 1 S a u n a & S t e a m HEAVY DUTY SAUNA HEATER Assembly and operating manual PRODUCT IMAGE Oceanic Ltd, Pountney Street, Wolverhampton, WV2 4HX Phone: 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk...
-
Page 2: Table Of Contents
12. Warranty & After Sales ........17 Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk... -
Page 3: Introduction
Sauna Heater Manual Introduction Thank you for choosing to buy our OCS B Series Sauna heater, please take the time to read these instructions before you begin as they contain important information about the installation and maintenance requirements. OCS B Series Sauna heaters are available from 9kw to 20.1kw and are equipped with our OC-SB digital controller &... -
Page 4: Sauna Heater Parameters
60~70 L:480 (H1-H6) 5×2.5 W:560 Terminal2: H:660 5×2.5 OCS180B 18.0 9×2.0 18 32 Terminal1: 80~90 (H1-H9) 5×4.0 Terminal2: 5×2.5 OCS210B 20.1 6×2.0 20 34 Terminal1: 80~90 (H1,H4,H7) 5×4.0 (H3,H6,H9) Terminal2: 3×2.7 5×2.5 (H2,H5,H8) Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk... -
Page 5: Temperature Sensor
Temperature sensor parameters. Chart 3 Cut off on high Detected scope Size (mm) temperature Model OC-S 0~110 32~230 Circuit Diagram for sauna heater and control Box Sauna heater circuit diagram Heating element Fig1a. OCS090B-0CS170B Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk... - Page 6 S auna light Ⅰ: ;Ⅱ : ;Ⅲ : Ⅵ HI TEM P CUT OFF S ens or D oor C ont roller Ⅳ: ; Ⅴ: ;Ⅵ: ;Ⅶ: M ANUAL RESET （ ） Voltage DC5V Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk...
-
Page 7: Parts Description
Cover Panel Cover the electrical parts terminal Connect the power supply Power entry The route of power wires Chart 4 7.2. OC-SB Controller frame and parts Fig 4. Controller frame Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk... - Page 8 Stop working LED indicator LED for stop working , the sauna room temperature exceed the preset temperature , the heat element pause(when temperature 2 centigrade lower than preset temperature ,sauna heater will work again, Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk...
- Page 9 Outlet of wires to heater ,light and fan and fasten wires output Control cable entry The entry of control cable Light terminal Connect to light wire Fan terminal Connect to fan wire Control panel terminal Connect to control cable Cover cover Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk...
-
Page 10: Installation
An electrical supply must do the installation of the heater to ensure safety and reliability. Improper electrical connection can cause fire or electric shock. Refer to fig 1a or fig 1b (Electrical connection chart).and fig 2 Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk... -
Page 11: Installation For Sauna Heater
Remove the cover panel and connect power supply wire and control cable through the wire anchorage to the Terminal as per fig 8 and replace the cover panel. Note: Do not short circuit output from control box to sauna heater Fig 8 Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk... - Page 12 Install the control so it sits flat on the wall. Fix using the screw holes 118mm apart. • Put the keypad cover back on, check the cover is completely on so that all the buttons click when pushed. 118mm Fig 10 Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk...
-
Page 13: Installing The Temperature Sensor
Replace the cover. Temperature Sensor 1800 Fig 11 Fig 12 INPUT POWER 400V 3N~ 50/ 60Hz OCS-B Control BOX lamp OC-SB Controller Temperature Sensor Terminal 1 Sauna heater Terminal 2 Door InterLock Switch Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk... - Page 14 Put the larger stones at the bottom of stove compartment and the smaller ones on top. Do not pile them tightly so that air can flow freely. NOTE: Too tightly placed stones decrease working time of the Fig 14 Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk...
- Page 15 (to the wash room). In this case, the sill slot must be at least 5cm and it is recommended there is mechanical ventilation in washroom the size of the outlet should be twice of the inlet. Warning: Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk...
-
Page 16: Testing And Operation
Default Time Time adjust scope Working time Waiting Work time Wait time OC-SB 2hrs 4hrs 10mins - 8hrs 0-12 hrs Time adjustment per button press Temperature adjustment per button press 10 mins C /2 Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk... -
Page 17: Setting Time And Temperature
– then the sauna Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk... -
Page 18: Trouble Shooting Guide
, the timing stoped and will not restart again until it is reset. Wait LED is on red Sauna heater is under B mode Press the Mode button to change to A mode (heating Mode) Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk... - Page 19 115 2. --H C means there is a short circuit in the temperature sensor or the temperature is higher than 115 C check the connection,cable or change sensor. 3.Change controller. Oceanic Saunas 01902 450 550 sales@oceanic-saunas.co.uk www.oceanic-saunas.co.uk...
-
Page 20: Maintenance
11.1. Sauna Heaters & Sauna Cabins Maintenance All Sauna products supplied by Direct Saunas Limited and Oceanic Saunas are for use in an indoor environment such as a domestic house or a club building and should not be used in any other circumstances.
Need help?
Do you have a question about the OCS B Series and is the answer not in the manual?
Questions and answers