Replacing The Solid-State Drive (Half-Length); Procedure; Post-Requisites - Dell XPS 15 Service Manual

Identifier
Status

Replacing the solid-state drive (half-length)

WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the
steps in Before working inside your
your computer. For more safety best practices, see the Regulatory Compliance home page at
regulatory_compliance.
Identifier
Status

Procedure

1 Align the screw hole on the solid-state drive bracket with the screw hole on the solid-state drive.
2 Replace the screw (M2x2) that secures the solid-state drive to the solid-state drive bracket.
3 Align the notches on the solid-state drive assembly with the tabs in the solid-state drive slot.
4 Slide the solid-state drive assembly at an angle into the solid-state drive slot.
5 Press the other end of the solid-state drive down and replace the screw (M2x3) that secures the solid-state drive to the system
board.
Identifier
Status

Post-requisites

1 Replace the battery (half-length)
2 Replace the base cover.
GUID-D3CEABFD-629C-4387-BE70-448237C2381D
Released
computer. After working inside your computer, follow the instructions in
GUID-0B4DFA25-CDC9-407D-A65A-234FFD38CFA5
Released
GUID-D6D9C7FD-F5F2-4841-BED9-C4F8672A8F1D
Released
or the battery (full-length).
www.dell.com/
Replacing the solid-state drive (half-length)
14
After working inside
33