Table of Contents
Advertisement
Timer screen
In oven mode you can change the temperature and run up to 4 count down
timers. Alternatively don't enter a time and it will maintain the set temperature
indefinitely.
The fan speed can be increased or decreased. A humidity injection level can
be set (this then operates in 30 second steps at the beginning of the
programmed cycle).
Return to
home
Tap to see actual
temperature
Touch to
enter time
Humidity can be added by pressing the humidity injection setting. In oven mode
humidity is added on demand. In program mode it is injected at the start of each
step.
Higher levels of humidity can be achieved by incorporating additional steps in the
cooking program and adding humidity within these steps.
Humidity injection levels can be set from 1 – 5.
FAULT FINDING
This appliance is fitted with a safety thermostat, which will cut power to the
appliance under fault conditions. If when turning the unit on it fails to operate firstly
check the power supply to the unit then the reset before contacting Lincat service.
To re-set the safety thermostat, firmly push the red button which is recessed under
the front edge of the unit see (Fig 3 – 4). This re-set cannot be activated until the
appliance is cool. If this continues to happen please call our service department.
Please refer to the Service Help Desk number on the final page of this manual.
IS 731 ECN 4421
Page 10 of 15
Temperature
setting
Fan speed
Humidity injection
level settings
Single or 4
shelf timer
mode
Advertisement
Table of Contents
