Spare Part; Repair Instructions - Brinkmann BFS Series Operating Instructions Manual

10 Spare part

10.1 Pump design BFS, TFS
10.2 Indications to the spare part order
Spare parts are available from the supplier.
Standard commercially available parts are to be purchased in
accordance with the model type.
The ordering of spare parts should contain the following de-
tails:
1. Pump Type
e.g. TFS364/60
2. Pump No.
e.g. 03186100
The date of the construction year is a component
of the pumps type number.
3. Voltage, Frequency and Power
Take item 1, 2 and 3 from the nameplate.
4. Spare part with item No.
e.g. Motor 1

11 Repair Instructions

11.1 Fitting the coupling
 Coat pump and motor shaft ends with a thin coat of
Molykote (e.g. Molybdenumdisulfphite) and insert the
woodruff key.
 Slide the pump coupling hub (6) onto the pump shaft by
using a rubber mallet. Move pump coupling hub down as
showing in following table and drawing.
If the hub installation is too difficult, warming up the coupling
hubs will simplify the hub installation.
 Secure the pump coupling hub (6) using the set screw (7)
 Clean motor shaft with solvent to remove any anti-rust
coatings. Then coat the motor shaft with a thin layer of
Molykote (e.g. Molybdenumdisulfphite) and insert the
woodruff key.
 Slide the motor coupling hub (4) onto the motor shaft to
dimension as shown in following table (Page 11) and draw-
ing
 Secure the motor coupling hub (4) using the set screw (7).
BE6100
FFS
Item Description
1
2
3
4
5
6
7
8
Edition 08/2018
Motor
Screw pump
Bell housing
Motor coupling hub
Coupling spider
Pump coupling hub
Set screw
Pump foot
Friedrichstraße 2 D-58791 Werdohl
Page 11 of 13