Uv Sterilization; Replace Uv Lamp - RBC Bioscience MagCore HF48 Operation Manual

━ UV Sterilization

Maintenance
UV Sterilization
Piston Test
O-Ring & Piercing Needles
DC Motor Operate
Please select Item
Select UV Sterilization in Maintenance menu.
Next Step
UV Sterilization
30min
30:00
select Item and press START to run
You may select 30min or 60min process in UV Sterilization menu.
Press START key to start sterilization after selection. The touch
screen will show the remaining time of sterilization at the same time
and will show Complete picture after the sterilization is completed.
Please press Stop to stop if you want to stop sterilization.
www.rbcbioscience.com
17
Moving Test
Heater Test
Rejection Tip
Update Program Files
60min
Start
Remaining Time
Complete
Back

━ Replace UV Lamp

Back
Open the top cover of the part chamber
Stop
Next Step
Back
Apply new UV lamp
Next Step
Status
System Date : 2012.12.12
System Time : 12:12:12
UV Lamp Operating Time : Hr:00 Min:00 Sec:00
UI Software Ver. : Ver.SUPER2012-0.1
PLC Software Ver. : Ver.SUPER2012-0.1
Machine serial number :
Error history list
Select Status key in the main menu and press UV Time Reset key to
reset the hours of UV lamp
Please test to see if UV lamp is normal after replacement
Please note the weight of the
top cover of the part chamber.
This step may need two people
to complete.
UV Time Reset
Back